Saturday, May 4, 2013

Simple solutions, leash, sock and picks

When I start thinking I know what I am doing I usually get a lesson in humility.



Umbilicals? To connect the umbilical to the tools we have mini lockers, flat steel wire gates and a host of do-it-yourself solutions with all offer varying amounts of success. How hard does it really need to be? Not very it seems. For the home made ones just tie a big loop in the end and do the same. Easy on and off for the alpine where you may want to remove the umbilical all together. Thanks Jim for pointing out that obvious solution to my my overly jaded imagination.

















Boots that don't fit perfectly? Feet a little different in size? Not unusual for most folks.



How about using different thickness sock on each foot? It might just be the simple fix you require to get a better fit. Not one I have needed but so simple when it was pointed out to me I had to say, "duuuu, of course!" It is at least worth a try. Thanks for that idea!







Another one that seemed to escape me and most of my climbing mates. Sharpening tools? For most things including vertical ice and the majority of alpine mixed a razor sharp pick isn't required. In fact it is just a waste of good steel (and your hard earned cash) to always be sharpening and resharpening your picks.



I know, BTDT myself on numerous occasions. And until now I am generally loath to go on anything I think is difficult without a set of "properly sharpened" picks. This spring I decided to see just how much difference it really makes. Short of super cold or old hard and brittle ice I suspect it doesn't matter much. Now I intentionally sharpen my picks differently.



I think the ability to hook the tools easily is equally important as getting the initial stick.

With the best of the new tools hooking is easy and secure. Which allows us to worry less about the condition of the pick's tip. Much as we want to think it really does and I have been convinced it does for years.








Pick at the left is now 3.3mm and the newer one on the right is 3.1mm




The difference in how the picks actually climb in the majority of terrain I use them on is nil.























To make a point the two sets of picks below started out new and got some use.









The pair above was used on the first ascent of Dracula, Mt Foraker.





This pair was used on a solo ascent of the Cassin, Denali





As I said unless it is really hard and cold or just old ice the pick can be pretty well worn and still very usable. More so than you might first think. Certainly on a lot of the mixed we do by simply hooking you don't need a razor's edge on your pick. The first time you miss judge a placement and slam the pick into rock you'll end up with a dull edge anyway. The cutting edge of a splitting maul will last a lot longer than that of a scalpel. Each has their own place in the tool box. Best to know which you need for your specific job.



I still have picks I haven't touched with a file that get used on fat Canadian ice. Going a full season there without intentionally hitting rock is not unusual. They start out sharp from the factory and stay that way if I pay attention. I also have the pair of picks I climbed on in Chamonix last winter. Down into the teeth on those simply from wear on the hard granite and old black gully ice there. One is the rounded and shortened pick seen in the first picture. The pair look remarkably the same.









I used that pair of picks on several pure ice climbs this spring including the scariest lead I have been on in a while. Sticks are easy in the spring time slush :) The shape of my picks never once entered my mind.
























No comments:

Post a Comment