"- We are NOT bringing back the Cascade pick for the Nomic. Perhaps this rumor is based on availability of the Cascade pick for the previous generation Quark, which is still in production.
- Same story for the 1st generation Griprest. We have no plans to bringthis one back, although there still may be some stock out there which could be feeding these rumors.
- There is no new Griprest on the horizon, however, the latest (post* Quality Alert) generation of the Nomic Griprest will fit the 1st Gen Nomic."
The still available 1st gen Quark Cascade picks can be easily cut down and used in any version of the Nomic for those that preferless "stick" water ice pick. And for durable dry tooling the old 4mm T rated Quad pick will work with little effortas well. Quad is my choice in the alpine if a lot of rock is involved. Might be better tothink of the Nomic as having 4 different picks available directly from Petzl.
Ally's originalQuad pick in a 1st gen. Nomic with a CT hammer. Winter of '10/11in Chamonix.
Either way easy enough to copy the Nomic blade pattern and reshape the lower back section of the older Quark picks to fit the Nomic. Only adding the clip inhole, if required, is difficult. The Quark Cascade pick tooth and back edge patterns are exact copies of the older Nomic Cascade picks. A few minutes work with a grinder and files. Add a spacer,bolt the new pick in and you are ready to rock!
Older Quark Cascade pick on the bottom, Nomic Cascade on top.
Obvious where you need to remove metal on the earlier picks to fit.
No comments:
Post a Comment